Magenta MULTIVIEW XR2000 Einstellungsanleitung PDF herunterladen (Seite 16)

MAGENTA MULTIVIEW™ SERIES

Appendix B. Setting Sync Signal

Output Termination

In some cases, it may be necessary to disable the 75-ohm termination of the video

outputs on the MultiView™ CAT5 Video System units. This can be done by opening

the case of each unit and installing jumpers on the circuit board. The settings disable/

enable the 75-ohm termination on individual units. For instance, changing a transmitter

termination affects the local monitor port only, it doesn’t affect the receivers.

Conversely, changing a receiver affects the output port of the receiver, not the

transmitter. The following diagrams show the jumper locations for the XRTx unit

75-ohm sync termination:

To enable: Both jumpers OUT (Default)

To disable: Both jumpers IN

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Keine Kommentare

Magenta MULTIVIEW XR2000 Einstellungsanleitung Seite 16